plex media server port forwarding settings

Be sure that when testing this port, TCP is open. You may need to open this port on your firewall. When testing to see if the port is open, always make sure the software that’s using this port is running - its always best to test from outside your network. When exposing a port to the Internet make sure you either lock down the login to your software, or allow specific IPs to access this port remotely over the VPN. Any ideas? Thanks guys.Port Forwarding lets you open a port to the internet while connected to the VPN - this can be used to allow remote access to software hosted on your network such as Plex or your NAS for example, there are some important notes you need to bear in mind though. On the plex support forums I read that the protocol should be TCP but I have also tried UDP and 'Both' in my router settings. (I have also tried combinations of same internal/external port 32400 and internal/eternal port that I was assigned by my VPN but nothing has worked so far). I am using a linksys E3000 router and thought based on the information from plex above that I should specify my internal port as 32400 but I would use the port that my VPN assigned as my external port. I use for my VPN and have set up my port forwarding with them although the port that they specify I am using is not the same as the 32400 required by plex. Important: While you can choose any valid WAN/external port number you desire, the mapping for the LAN/internal port must always be 32400. IP Address: The local IP Address of the computer running the Plex Media Server. LAN/Internal Port: This will always be 32400. WAN/External Port: Port 32400 is default, but you can generally use any available port in the 20,000 to 50,000 range. In order to forward a port for Plex Media Server, you'll need three main pieces of information: Here is what plex says in their help section about port forwarding Plex says I am successfully signed in but it cannot reach my server from outside of my network.

Hi, I am attempting to set up port forwarding for my plex media server so I can access from outside of my home network however I am running into some issues.

Plex media server port forwarding settings